Phobya 13mm (1/2') Fitting G3/8 with O-Ring (High-Flow)
High-flow barbed fitting for hoses with an inner diameter of 11mm to 13mm. This fitting was specially designed for High-flow systems.
High-flow barbed fitting for hoses with an inner diameter of 11mm to 13mm. This fitting was specially designed for High-flow systems.
Technical data:
Thread: 3/8"
Compatible to hoses with an inner diameter of 11mm to 13mm
Note for watercooling beginners:
The connectors for imperial hoses(7/16", 3/8", œ") are provided with measurements in mm in our shop. These can differ by +-1mm, which is no problem as hose clamps have to be used for installation. If the hose is to be mounted without a clamp, a larger fitting should be chosen. With some fittings that tend to be larger, it is possible though that a hose with an inner diameter of 13mm actually does seal without a hose clamp.
Overview:
10mm (3/8") hose clamp: up to 8mm none, from 10mm up required
10mm (7/16") hose clamp: up to 8mm none, from 10mm up required
12mm (1/2") hose clamp: up to 11mm none, from 12mm up required
13mm (1/2") hose clamp: up to 11mm none, from 13mm up required
Questions & Answers
Download PDF
SAME DAY SHIPPING
Most orders ship same day or use our Rush Service.
100% SATISFACTION
Our promise you will always be happy with your purchase.
ONLINE SUPPORT 24/7
Use Email, chat or phone for any tech or order help.
